ENGLISH
5
PARTS & ASSEMBLY
Parts
After Taking the Unit Out of the Box
Wipe down the SOFT SERVE ICE CREAM MAKER exterior with a clean, non-abrasive cloth
or sponge. Thoroughly wash Blending Chamber, Aluminum Cylinder, Cylinder Cage
and Lid in warm, sudsy water and thoroughly dry. DO NOT put the Base in water.
Assembly
1. After drying, rmly attach Blending Chamber to Base
by placing the Blending Chamber on top of Base. If
Blending Chamber is attached properly, it will be aligned
with Base so that the Spout is over the Drip Tray.
2. Next, put Mixing Mechanism inside of Aluminum Cylinder
and put Aluminum Cylinder inside of Cylinder Cage. Then
place Cylinder assembly inside of Blending Chamber.
Blending Chamber
Drip Tray
Base
Blending Chamber
Lid
Spout
Non-Stick Aluminum
Cylinder
Cylinder Cage
Mixing Mechanism
To Next Page
Loading...
