EasyManua.ls Logo

Nostalgic AC CK-7586258 User Manual

Nostalgic AC CK-7586258
16 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
Important information about your new a/c system.
Please read the following directions prior to
installing this a/c system.
PN’s: CK-7586258, CK-758642,
CK-7586304, CK7586SBC, CK-7486NC
Jeep CJ Series
Aftermarket Air Conditioning
Installation instructions
&RQWDFWXVE\HPDLORUSKRQHLI\RXQHHGDQ\DVVLVWDQFHRULQIRUPDWLRQUHJDUGLQJWKLVDFV\VWHP

6$/(6#1$&.,76&20
Jeep Wrangler is a registered Trademark of Daimler Chrysler Corporation
3$*(

Table of Contents

Question and Answer IconNeed help?

Do you have a question about the Nostalgic AC CK-7586258 and is the answer not in the manual?

Nostalgic AC CK-7586258 Specifications

General IconGeneral
BrandNostalgic AC
ModelCK-7586258
CategoryAir Conditioner
LanguageEnglish

Summary

System and Warranty Information

CJ A/C Kit Installation Overview

Evaporator and Blower Unit Setup

Instructions for installing the evaporator unit and ensuring the blower motor spins freely.

A/C System Wiring Guide

Details on connecting the three main wires for the a/c system, including fuse, plug, and ground.

Parts List

Vehicle Preparation: Step One

Disconnect Battery and Remove Ashtray

Disconnecting the battery cables and removing the dashboard ashtray before installation.

Evaporator Installation: Step Two

Mounting the Evaporator Unit

Attaching the evaporator unit to the dashboard and securing it with self-tapping screws.

Drier Installation: Step Three

Mounting the Drier

Mounting the drier on the inner fender well, ensuring correct orientation.

Condenser Installation: Step Four

Mounting the Condenser

Mounting the universal condenser to the core support, aligning for passenger side fittings.

Compressor Installation: Step Five

Mounting Compressor and Bracket

Mounting the compressor and its bracket, noting pre-filled oil.

Hose Connection: Step Six

Connecting Air Conditioning Hoses

Details on sizing, crimping, and connecting hoses, including o-rings and grommets.

Finalizing Installation: Step Seven

System Wiring and Charging

Wiring the system, charging with R-134a refrigerant, and performing final checks.

Installation Supplement

Gas Pedal Adjustment Procedure

Instructions for adjusting the gas pedal to prevent interference with the blower housing.