Nova 6000 Series - Component Installation and Repair; Elevating Legrest and Armrest Operations; Upholstery Replacement and Wheel Maintenance

ELEVATING LEGREST ASSEMBLY
INSTALLING ELEVATING LEGREST
1 - Hold the legrest assembly in position as if it were in ready for use.
2 - Turn the front legrest assembly to the side (so that open foot plate, which was
perpendicular to the wheel, is now parallel with the wheel).
3 - Slightly raise the assembly and place the hinge plates on the front legrest assembly
onto the hinge pins on the product frame.
4 - Rotate the legrest assembly inward, toward the inside of the wheelchair until it locks
into place (so that the foot plate is perpendicular with the wheel).
5 - Repeat for other legrest assembly.
REMOVING ELEVATING LEGREST
1 - Push the release lever inward.
2 - Rotate the front legrest assembly to the side (so that open foot plate, which was
perpendicular to the wheel, is now parallel with the wheel).
3 - Slightly lift the legrest assembly so that it comes off the hinge pins.
ADJUSTING ELEVATING LEG REST
1 – RELEASE the tension screw by pulling on the black plastic lever
2 - PRESS the leg rest release push buttons and adjust to your desired setting
3 - Ensure that the leg rest release button re-engages (push-buttons click in place).
4 – PRESS the tension screw back into place
5 – Swivel the calf pad down so that the patient’s calf area rests on it
ARMRESTS
INSTALLING ARMREST
1 - PRESS the armrest release levers at the front the armrest so the brass release pin
retracts into the tube.
2 - Lightly position the armrest in the front and rear armrest sockets
3 - Push armrest down evenly and so the brass pin locks into place.
4 - Ensure the armrest is secure by gently pulling up on the armrest.
5 - If armrest is loose, or not locked in place, then repeat above steps.
REMOVING ARMREST
1 - Push down armrest to ensure proper position prior to removal.
2 - PRESS the armrest release push button at the front of the armrest.
3 - While pushing in on the armrest release buttons, pull straight up on armrest to
remove.
REPLACE SEAT AND BACK UPHOLSTERY
1 - Remove the Phillips screws and washers, replace upholstery, and reattach screws
6 of 8