Titan – Cleaning
STEPS DESCRIPTION IMAGE
1.
Use a disposable cloth/ towel to wipe
off much of the visible dirt as possible
on each part.
2.
To remove built up grime, apply a
degreaser/rust remover (e.g. WD40)
on each part. Leave on for at least two
hours (or as directed on product
instructions).
3.
Use a wired brush to remove the rust
and grime.
4.
Use a clean disposable cloth/ towel to
wipe the part after brushing.
The parts should feel dry and
shouldn’t leave any sticky residue on
your fingers.
p.22
To Next Page
Loading...