To Next PageTo Next Page
Need help?Do you have a question about the Novoferm tormatic NovoCon T75 DES and is the answer not in the manual?
General| Manufacturer | Novoferm |
|---|---|
| Model | NovoCon T75 DES |
| Category | Control Unit |
| Operating voltage | 230 V AC |
| Operating temperature | -20°C to +60°C |
| Protection class | IP54 |
| Connection type | Screw terminals |
| Radio frequency | 433 MHz |
| Compatible motors | Novoferm garage door openers |
| Functions | automatic closing |
| Transmission power | 10 mW |
| Dimensions (H x W x D) | 50 mm |
Identifies the NovoCon T75 DES model and its software release.
List of available languages for the operating and installation manual.
Diagram of all terminal connections for inputs and outputs.
Wiring diagrams for various power supplies and motor connections.
Identification of key components on the control unit interface.
Procedure for configuring the upper and lower end positions of the door.
Fine-tuning end positions and selecting safety devices like light barriers.
Configuring safety edge cut-off and programming radio remote controls.
Essential safety guidelines, warnings, and product information.
Key technical data including voltage, power, and environmental ratings.
Step-by-step instructions for the physical installation of the unit.
Comprehensive guide to the control system's programming menus and functions.
Explanation of different operating modes and how to interpret status indicators.
Table of common faults, their causes, and recommended solutions.
Forms for documenting system inspections and maintenance activities.
Official declaration of the product's compliance with relevant directives.
