Your excellent helper in laser distance test! Your excellent helper in laser distance test!
07 08
3.10. Addition & subtraction measurement
Under the Single, Area, Volume measurement
mode, press " " to get a result "A", then
press " " or " ", press " " again
to get a another result "B", then it will auto
matically calculate the value ("A+B "or "A-B").
+
-
3.11. Unit switching
Long press " " 2s to switch the unit,
optional from (0.000m→0.00m→0.00ft→
0'00''%→0.0in→0%in)
3.12. Benchmark switching
Press " " to go in, you can set the
benchmark to measure from the front side
①, or from the end side ②.
① ②
3.8. Level measurement （ ）
Pres " " to go in when the testeing mode
in Pythagorean measurement ②, then press "
" to get the ①, it will automatically
calculate the angle degree between the
hypotenuse and the horizontal edge, vertical
Length "H" and horizontal length "L".
①
0
H
L
3.9. Vertical measurement（ ）
Pres " " to go in when the testeing mode
in Level measurement, then press " " to
go in, then press " " to get the ① & ② length,
it will work out the degree "0" and length "L".
①
②
0
L
To Next Page
Loading...