Do you have a question about the NOYAFA NF-8108 and is the answer not in the manual?
Type | Network Cable Tester |
---|---|
Model | NF-8108 |
Testing Range | Up to 300 meters |
Cable Faults Tested | Open, Short, Cross, Reverse |
Length Measurement | Yes |
Main Tester Port | RJ45 |
Remote Unit Ports | RJ45 |
Display | LCD |
Cable Types Tested | STP, UTP |
Power Supply | 9V battery |
Length | Not applicable |
Color | Black |
Shielding | Not applicable |
Conductor Material | Not applicable |
Jacket Material | Not applicable |
Explains how to use the WireMap function to check wiring diagrams and locate errors.
Describes the display and handling of short circuit test results.
Explains the display and cause when the remote unit or cable is not properly connected.
Shows the expected display for a normal wiring diagram test with the remote unit.
Explains how to identify an open circuit at the far-end of a cable using the WIREMAP function.
Explains how to identify an open circuit at the near-end of a cable using the WIREMAP function.
Explains how to identify an open circuit in the middle of a cable using the WIREMAP function.
Describes the display for short circuits during pair and length testing.
Shows the expected output for normal pair and length measurement results.
Explains results for unpaired lines and abnormal length measurements.
Describes how to interpret OPEN or SHORT results for coaxial/telephone lines.