NRS Healthcare Mowbray Lite Series User Manual

1
USER INSTRUCTIONS
MOWBRAY LITE TOILET FRAME AND SEAT
RANGE
M66613 Flat Pack - Adjustable Width M66625 Standard - Fixed Width Assembled
M92740 510 - Fixed Width Assembled N36974 Adjustable Width Assembled
General Safety Warning
Please make sure that you read and follow these
instructions carefully. Failure to do so can result in
injury. Keep these instructions in a safe place for
future reference.
Maximum User Weight
30st
190kg
INTENDED USE
The Mowbray Lite toilet frame and seat range is designed to assist those who have diffi culty in lowering
onto or rising from a standard toilet. The plastic moulded seat offers support in a natural position and the
frame is height and width* adjustable.
(*Only available with M66613 – Mowbray Lite Flat Pack)
SAFETY
Read these instructions before installation and use.
This product must be correctly assembled, installed,
and maintained.
Do not exceed the maximum User Weight.
UNPACKING
Check product carefully before installation/use. If
you see, or suspect a fault, do not use, contact your
supplier immediately.
Note: M66625, M92740 & N36974 are delivered
ready assembled.
M66613 is supplied fl at packed
Contents (M66613 only):
1. Toilet seat x 1
2. Frame Side LH x 1
3. Frame Side RH x 1
4. Frame Centre Bar x 2
5. Leg Assembly x 4
6. E-clips x 8
ASSEMBLY
1. M66613 - Mowbray Lite Flat Pack:
Assemble the frame sides to the centre bars, set
to the correct width, align the holes and secure
with the four e-clips provided
2. N36974 - Mowbray Lite Adjustable Width As-
sembled:
The frame comes ready assembled. To set to
the width, remove e-clips and slide the frame
side tubes in the frame centre bars until the
desired width is achieved, align the holes and
secure using the four e-clips provided.
3. All Models
Remove the moulded seat from its protective
bag and snap into place on the centre bars of
the frame, ensure the seat is fi rmly in place and
secure at both back and front.
4. Adjust to the required height by removing each
‘E’ clip in turn and slide each leg up or down
to the required height. Align the holes in and
replace ‘E’ clip. (See diagram overleaf)
5. Ensure that all leg extensions are set at the
same height to prevent rocking.

NRS Healthcare Mowbray Lite Series Specifications

General

Product Name	NRS Healthcare Mowbray Lite Series
Category	Bathroom Aid
Height Adjustable	Yes
Foldable	No
Armrests	Yes
Wheels	No
Brakes	No
Maximum User Weight	190 kg
Height	66 - 82 cm

Summary

General Safety Warnings

Safety Instructions

Read and follow all instructions carefully to ensure safe use and for future reference.

Intended Use

Product Purpose

Designed to assist users with difficulty lowering onto or rising from a standard toilet.

Assembly Instructions

Mowbray Lite Flat Pack Assembly

Assemble frame sides to centre bars, align holes, and secure with e-clips.

Mowbray Lite Width Assembled

Frame comes ready assembled; set width by removing e-clips and sliding tubes.

All Models - Seat Attachment

Remove seat from bag, place on protective bars, ensure firm fit, and secure at both back and front.

Safety and Unpacking

Usage Safety

Read instructions before installation/use. Ensure product is correctly assembled, installed, and maintained.

Unpacking Procedure

Check product carefully before installation/use. Contact supplier if a fault is suspected.

Cleaning and Maintenance

Seat Cleaning

The seat can be removed and autoclaved at temperatures up to 70°C.

Frame Cleaning

The frame may be cleaned using a non-abrasive cream cleaner or detergent solution.

Component Checks

Check ferrules monthly for wear, and floor fixing screws weekly.

Floor Fixing Kit Instructions

Floor Fixing Kit Overview

A Floor Fixing Kit is available as an accessory for a permanent fix.

Leg Installation

Remove existing legs, attach floor fixing legs, adjust height, and secure with e-clips.

Securing to Floor

Fix legs to the floor using twelve screws appropriate to floor construction.

Product Information

Accessories and Spare Parts

Lists available spare parts like Floor Fixing Kit, Ferrule, and Seat.

Product Disposal

Clean thoroughly before disposal via local waste centres or collectors.

Product Guarantee

12-month guarantee against faulty materials/workmanship, excluding misuse or tampering.