INSTALLATION & OPERATION MANUAL
2 | P a g e w w w . n t e n g i n e e r s . i n
SAFETY ADVISE / WARNING
WHEN THE DEVICE IS IN OPERATION, HAZARDOUS VOLTAGES WHICH CAN BE
FATAL TO HUMAN LIFE ARE PRESENT INSIDE THE ENCLOSURES AND AT THE
CONNECTION TERMINALS. PLEASE FOLLOW PROPER SAFETY WHILE
HANDLINE AND INSTALLING THE EQUIPMENT.
Touching live electrical parts can cause a fatal shock or severe burn. Operating
the plasma system completes an electrical circuit between the torch and the
workpiece. The workpiece and anything touching the workpiece are part of the
electrical circuit. Never touch the torch body, workpiece or the water in a water
table when the plasma system is operating. Install and ground this equipment
according to the instruction manual and in accordance with national and local
codes.
Before removing any power supply or system enclosure cover, disconnect
electrical input power. Wait 5 minutes after disconnecting the main power to allow
capacitors to discharge.
Never operate the plasma system unless the power supply covers are in place.
Exposed power supply connections present a severe electrical hazard.
When making input connections, attach proper grounding conductor first.
To Next Page
Loading...
Need help?
General