INSTALLATION & OPERATION MANUAL
4 | P a g e w w w . n t e n g i n e e r s . i n
Features
DigiCut THC Plasma Height Control is an automated height control system for automated plasma
cutting applications. This product uses microprocessor technology to automatically detect the plate and
adjust torch position to an arc voltage set point during plasma cutting operations. This reduces operator
input, improves accuracy and increases productivity.
Features
• DigiCut THC is Fully standalone and can be used with any CNC Controller
• Easy setup and Operation
• Automatic & Manual Operation Modes
• Microprocessor based for increased sensitivity and control
• Graphic LCD display for set/actual voltage display, parameter settings
• Stepper / Servo motor based Z Axis control for higher precision & accuracy.
• Provides ISOLATED STEP & DIRECTION signals for Stepper / Servo Driver. (Driver Not
included)
• Dual Speed IHS (Initial Height Sensing) for both Ohmic and Floating.
• Adjustable pierce height and cut height in 0.1 mm intervals
• Adjustable pierce delay in 0.1 sec intervals
• LED outputs for easy status indication for Cut, Up, Down, Plasma start, Motion Start, and Auto
/ Manual.
• Host of Settings for fine tuning system operation.
To Next Page
Loading...
Need help?
General