NTC HC10B - User Instructions and General Information

4
User instructions - General information.
A) What HC10B does
P HC10B is a digital thermostat for precise control of electric underoor heating.
P HC10B starts automatically in Quickstart = Manual mode and oor sensor
P HC10B can also perform night and day setback in three different ways
B) IMPORTANT!
Important information before connecting the underoor heating
P To ensure optimum service life of the underoor heating, the material in which
the heating system is laid must be allowed to dry for a minimum of 28 days
before switching on the heat.
P A new installation of HC10B and underoor heating must be carried out by an
authorised electrician.
P Exchanging an HC10B, is allowed to do by the end-user in most countries.
P HC10B must not be covered.
C) Programs in HC10B
C.1) Quickstart
PSwitch on and the underoor heating will start up.
P The temperature is set to 21°C
LThe temperature can be altered with [q] or [p]
The display shows the set temperature
P The oor sensor will automatically start operation
C.2) Night and day setback programs
P HC10B holds three different night and day setback programmes.
P They each control the temperatures and time settings. i.e. low temperature at
night and during working hours, higher temperature at morning and evening.
P For each program the starting time and temperature are determined. Start times
and temperatures are set at the factory, but can be changed as required. The
factory setting is shown in Table 1.
P Night and day setback ensures minimum power consumption. With optimum
adjustment of the underoor heating the average temperature can be dropped
by up to 3°C, giving potential power savings of up to 15%. The savings will
naturally depend on the circumstances and on what you want from the
underoor heating.
P Max. and min. limits are in all programs Max: 27°C Min.: 15°C.
Program 1: Settings for Monday to Friday, and settings for Saturday and Sunday.
Program 2: Settings for All Weekdays.
Program 3: Settings for Each Day of the Week separately.
Table 1: Factory setting for night and day setback.
Times and temperatures can be changed as required. See section 3.4) and 3.5).
Program 1: Settings for Monday to Friday, and settings for Saturday and Sunday.
Time zone Mon - Fri Temperature Sat - Sun Temperature
Wake 5:00 – 8:30 22°C 7:00 – 23:00 22°C
Leave 8:30 – 15:00 18°C
Home 15:00 – 22:00 22°C
Sleep 22:00 – 5:00 18°C 23:00 - 7:00 18°C
UK