Congratulations! Thank You for
purchasing NuBrilliance
TM
Hairless
TM
!
Amazing Results!
NuBrilliance
TM
Hairless
TM
removes facial
hair gently, safely & instantly.
BEFORE USING YOUR HAIRLESS, PLEASE
READ THIS INSTRUCTION MANUAL
CAREFULLY AND COMPLETELY.
Important Safeguards/Warning
1. Use Hairless
TM
only for purposes
described in this instruction manual.
2. Hairless
TM
is recommended for use on
one person only. For hygienic reason,
the hair removal head should not be
shared with others.
3. If you have any skin conditions or
other medical issues, please consult
with your physician prior to use.
4. Do not use on skin that is red, irritated,
inflamed, infected or blistered.
5. Do not use on warts, sores or open
wounds.
6. Discontinue use immediately if you
experience any pain or irritation.
7. Do not continually rub the unit on the
same area or apply strong pressure.
8. Overusage may cause skin irritation.
9. Exercise caution when using around
eyes.
10. This appliance is not intended for use
by persons, including children, with
reduced physical, sensory or mental
capabilities, or lack of experience and
knowledge, unless they have been
given supervision or instruction concern-
ing the use of the appliance by a
person responsible for their safety.
11. Keep your unit out of reach of
children.
12. Do not place or store your unit in
direct sunlight. Please store your unit in a
cool, dry place at a temperature
between 0-40°C. Keep the appliance
dry when it is not in use.
13. Do not turn your unit on if the hair
removal head is not attached.
14. Do not drop or insert anything into
any opening of the unit.
15. Do not disassemble this device.
16. Keep the protective cover on your
unit when it is not in use.
Battery Installation
1. Open the battery cover by turning it
counter-clockwise. Lift it off to reveal the
battery compartment (Fig. 1).
2. Insert 1 x AA battery (not included)
into the battery compartment. Observe
polarity (Fig. 1).
3. Close the battery compartment by
placing the cover back on and then
turning it clockwise until it clicks into
place and locks.
Usage
1. Remove the protective cover from the
unit (Fig. 2).
2. Turn on the unit by sliding the ON/OFF
switch up (Fig. 3). The built-in light will
also turn on automatically.
3. To remove hair, move the device in
circular motions, applying gentle
pressure over the desired area.
Do not press hard.
4. Stop and check often if you have
achieved the results you desire.
5. Turn off the unit by sliding the ON/OFF
switch down.
6. Place the protective cover back on.
NOTE: It is normal for the hair removal
head to become warm with use.
NOTE: It is gentle enough to use every
day.
SAVE THESE INSTRUCTIONS.
FOR HOUSEHOLD USE ONLY
NuBrilliance
TM
Hairless
Item # 2015FE/2062FE/2098FE/2099FE/2100FE/2124FE/2180FE
Distr ibuted by EMS ON® New York, N Y 10001, USA
©2018 EMSO N® All Right s Reserved . Printed in Ch ina.
Customer Service: 1-800-423-4248
Cleaning
Clean the appliance after each use to
ensure best performance.
1. Make sure the unit is turned off.
2. Remove the protective cover from the
unit.
3. Remove the hair removal head by
turning it counter-clockwise and then
Protective
Cover
Hair Removal
Head
Built-in Light
Slide ON/OFF
Switch
Battery Cover
ULTIMATE
HAIR REMOVER
INSTRUCTION MANUAL
PARTS IMPORTANT SAFEGUARDS IMPORTANT SAFEGUARDS BATTERY INSTALLATION USAGE USAGE CLEANING
lifting it off (Fig. 4).
4. The hair removal head comes apart
as shown in Fig. 5. Be careful not to
misplace any of the 4 parts.
5. Empty any hair residue into a trash
can. NuBrilliance
TM
Hairless
TM
is water
resistant (IPX4), and it can be rinsed
under water for cleaning.
6. Assemble all parts in order
as per Fig. 5.
7. Close the unit by placing the hair
removal head back on and then turning
it clockwise until it clicks into place and
locks.
8. Place the protective cover back on.
9. Wipe the unit with a lightly moistened
cloth. Do not use abrasive cleaners.
CLEANING
Fig.1
Fig.2
Fig.3
White Ring
Blade
Blade Shield
Blade
Cover
Fig.5
Fig.4
To Next Page
Need help?
General
