MEGAWATT BIKE GUIDE 2022 | 1 3
3. Line the pedal up to the driveside crank,
place your 8mm hex key through the driveside
crank and into the back of the pedal axle.
Start to turn the hex key in a clockwise
direction (as you look at the crank towards the
handlebars). There should be no resistance
as you turn the hex key, if there is resistance
STOP immediately and check you are tting
the correct pedal and the threads are correctly
aligned between the axle and crank. Do not
force the pedal into the crank.
4. Take your LEFT pedal and grease the axle.
5. Line the pedal up to the non-driveside
crank, place your 8mm hex key through the
non-driveside crank and into the back of
the pedal axle. Start to turn the hex key in
a anticlockwise direction (as you look at the
crank towards the handlebars). There should
be no resistance as you turn the hex key, if
there is resistance STOP immediately and
check you are tting the correct pedal and
the threads are correctly aligned between the
axle and crank. Do not force the pedal into the
crank.
6. With both pedals now on the crank arms,
tighten to 30Nm with a torque wrench.
Your pedals are now tted and safe to ride.
To Next Page
Loading...
