05
LED Power Display
The breast pump display features three power frames for easy monitoring.
Please note that the pump cannot be used while charging. During charging,
the display interface will only show the power level.
Power level shows 1 bar
and ashing: the battery
is running low; charge it as
soon as possible.
Power level shows three bars
and is no longer ashing:the
battery is fully charged.
English
Please disassemble each accessory individually for cleaning and sanitizing before using.
Be cautious when cleaning the valve and silicone diaphragm. To clean the valve and silicone diaphragm, gently rub it between
the thumb and forenger in warm, soapy water. Avoid inserting anything into the valve that could damage it.
Warning
First Time Use After Each Use
Pump Motor
Turn on the pump by pressing the power
button.
Wipe with a clean damp cloth with 70% ethyl alcohol or
isopropyl alcohol as needed. Do not immerse the pump
in water.
Flange, Silicone
Diaphragm, Valve, Linker and
Milk Collector
Boil in water for 5 minutes. Do not
microwave the Flange, Silicone Diaphragm,
Valve, Linker and Milk Collector.
Clean with mild dish washing soap or clean water.
The accessories can be sterilized by boiling or soaking
them for 5-8 minutes in boiling water. The sterilization
temperature of accessories should not exceed 100 C.
Cleaning
Cleaning & Maintenance
To Next Page
Loading...