06
Assembly
To assemble the pump, follow the steps below.
CAUTIONS
Make sure that you clean the pump as instructed in this user manual.
Make sure that you assemble the pump correctly as instructed in this user manual.
To avoid leakage, remove the residue around the rim before assembling.
Wash your hands thoroughly before you assemble cleaned components.
Place the silicone diaphragm inside the milk container
and apply pressure. Get a perfect seal by using your
hands to make the borders fasten tightly.
Install the valve to the bottom of the breast milk collector,
and install it in the correct direction.
2
1
To install the ange on the milk collector, make sure
to align the diversion groove on the ange with the
backow groove on the milk collector, and then press
the edges with both hands to ensure the seal is in place.
3
Install the main body of the breast pump on the milk
collector, align the notch under the main body with the
silicone diaphragm, and assemble it downward to t the
milk collector to ensure a complete seal.
4
English
To Next Page
Loading...