5
ASSEMBLY INSTRUCTIONS
3) The top crossbar with metal bracket (E) is pre-
assembled. Place an M6 nut cap (KK) over each
pre-installed nut.
Repeat procedure for the three remaining top
crossbars with metal brackets (E). See
Figure 3.
Figure 3
KK
E
Hardware Used
Part Description Quantity Picture
KK
M6 nut cap 8
4) Insert a top crossbar (D) into a top crossbar
with metal bracket (E). Line up the holes and
insert two M6 x 30 L bolts (BB) through the top
crossbar with metal bracket (E) first, and then
through the top crossbar (D). Fasten with an M6
nut (GG) using the provided wrenches to tighten
the M6 x 30 L bolts (BB). Do not overtighten!
Place an M6 nut cap (KK) over each M6 nut
(GG).
Repeat the procedure for the three remaining top
crossbars (D) and top crossbars wit
h metal
brackets (E). See Figure 4.
Figure 4
BB
E
D
GG
KK
Hardware Used
Part Description Quantity Picture
BB
M6 x 30 L bolt 8
GG
M6 nut 8
KK
M6 nut cap 8
5) Place one assembled crossbar (D & E) on top
of the side panel posts (A). Line up the holes at
each end of the assembled crossbar (D & E)
with the holes in the top of the side panel posts
(A). Insert an M6 x 80 L bolt (DD) through the
holes furthest from the corner.
Note: The holes closest to the corner are used in
Step 6 to secure the "L" connect bracket (HH).
Do not secure them in this step.
Fasten with an M6 nut (GG) using the provided
wrenches t
o tighten the M6 x 80 L bolts (DD).
Do not overtighten!
Place an M6 nut cap (KK) over each M6 nut
(GG).
Repeat this procedure for the other side of this
corner, the three remaining assembled
crossbars (D & E), and the side panel posts
(A). See Figure 5.
Figure 5
A
D
E
DD
GG
KK
Hardware Used
Part Description Quantity Picture
DD
M6 x 80 L bolt 8
GG
M6 nut 8
KK
M6 nut cap 8
To Next Page
Loading...