6
ASSEMBLY INSTRUCTIONS
6) Place one "L" connect bracket (HH) on the top
of an assembled crossbar (D & E) and line up
the holes. Insert an M6 x 80 L bolt (DD). Fasten
with an M6 nut (GG) using the provided
wrenches to tighten the M6 x 80 L bolts (DD).
Do not overtighten!
Place an M6 nut cap (KK) over each M6 nut
(GG).
Repeat the procedure to attach the three
remaining "L" connect brackets (HH). See
Figure 6.
Figure 6
E
D
DD
HH
KK
GG
Hardware Used
Part Description Quantity Picture
DD
M6 x 80 L bolt 8
GG
M6 nut 8
HH
"L" connect bracket
4
KK
M6 nut cap 8
7) Assemble the canopy frame bars (F), to the
short connect bars (G) by pressing the button
on the short connect bar (G) and inserting into
the canopy frame bar (F). The button will pop
out of the hole on the canopy frame bar (F)
when it is secure.
Repeat the procedure for each of the three
remaining short connect bars (G).
Follow the same process to assemble the
canopy frame center piece (C) to the canopy
frame bars (F). See Figure 7.
8) Place the large canopy
(I) over the top of the
assembled frame (C, F and G) and align the
seams of the large canopy (I) with the frame
bars (F & G). See Figure 8.
Pull the top piece of the canopy frame bars (F)
out from under the large canopy (I). See
Figure 8.
IMPORTANT! Do not slip the corner pockets of
the large canopy (I) into the end of the short
connect bars (G) in this step. This takes place in
Step 12.
Figure 8
I
F
F
G
C
G
F
F
C
C
Figure 7
To Next Page
Loading...