How to disable the PWR ON PLAY, and PWR ON DEMO features
The MIXDECK ships with two features enabled that are intended to help stores and dealers easily demonstrate the
product on their showroom floors: PWR ON DEMO, and PWR ON PLAY.
PWR ON DEMO – shows off the illuminated platter, using the RED LEDs to present a light show even if nothing is
playing on the MIXDECK.
PWR ON PLAY – when this feature is enabled, if you leave a disk in the deck, it will automatically begin to play
the next time you power-on your MIXDECK.
To disable either of these features perform the following steps on both the left and right decks on the MIXDECK.
1. Press and hold the PROG button located the lower-left of the screen.
2. While holding down the PROG button, turn the PARAMETER knob until the feature you’d like to change is
displayed:
3. While continuing to hold down the PROG button, press the PARAMETER knob (like a button). The text on the
screen will flash.
4. Now, (while continuing to hold down the PROG button) rotate the PARAMETER button to change the option from
ON to OFF. Press the PARAMETER knob (like a button) once more to confirm your selection.
The text on the screen will stop flashing, and the display should read the following:
5. Release the PROG button.
To Next Page
Loading...
Need help?
General
