What to do if my Numatic Dryer just stops while operating?
If the Numatic Dryer stops during operation, it might be due to excessive load on the brush system. Try resetting the machine using the key and decrease the brush load to better suit the task.
Why my Numatic Dryer machine will not operate?
If the Numatic Dryer machine will not operate, check the following: * Missing or blown fuses: Fit or replace the fuse. * Key in the ‘OFF’ position: Turn the key to the ‘ON’ position. * Low battery charge: Charge the batteries. * Machine isolator button in ‘OFF’ mode: Reset the isolator. * Machine is connected and charging: Take off the charge.
How to fix poor water pick-up in Numatic Dryer?
If there's poor water pick-up with your Numatic Dryer, the possible causes are: * Waste-water tank full: Empty the waste-water tank. * Clogged / blocked vacuum hose: Remove and clean the hose. * Loose hose connections: Push tight the connections. * Low battery charge: Recharge batteries.
Why is there no brush or scrub function on my Numatic Dryer?
If there is no brush or scrub function on your Numatic Dryer, make sure the brush deck is lowered.
What to do if the chemical dosing tank is empty in Numatic Dryer?
If the chemical dosing tank is empty on your Numatic Dryer, fill the dosing-tank and adjust as desired.
General| Model | TTV678-300 |
|---|---|
| Category | Dryer |
| Frequency | 50 Hz |
| Voltage | 220-240 V |
| Power Consumption | 1500 W |
To Next Page
