Numatic WV 1500 - Fault Finding and Declaration; EU Declaration of Conformity

Fault Finding - Dry - Wet - Declaration Document
This machine can be used for wet and dry pick up.
Dry Mode maintenance / fault nding
If the vacuum cleaner stops working switch off and remove the plug from the wall before
investigating were the fault lies.
If the vacuum cleaner will not pick up any debris from the surface, switch off and remove the plug from the
wall, inspect the oor tool, wands and hose for blockages, if no blockages are found, the dust bag may be
full if the dust bag is not full the lter may be blocked.
Wet mode / fault nding
If the vacuum cleaner stops working switch off and remove the plug from the wall before
investigating were the fault lies.
If the vacuum cleaner has a blockage and will not pick up liquid, switch off and remove the plug from
the wall, has the oat valve operated, this will shut off the suction and the pitch of the vacuum motor will
change Remove the power head and empty the liquid out of the container, if the container is empty, check
that the oor tool wands and hose are not blocked.
After use always inspect the machine for damage.
10
EU DECLARATION OF CONFORMITY
We hereby declare that the following equipment ful ls all the
relevant provisions of:
Machinery Directive 2006/42/EC
EMC Directive 2004/108/EC
Low Voltage Directive 2006/95/EC
Machine Description: Vacuum Cleaner
Type: WVD, WV series
Manufactured by: Numatic International Limited
This equipment has been designed and manufactured
in accordance with the following harmonised European
standards:
IEC60335-2-69:2002 +A1:2004 +A2:2006
IEC60335-1:2001 +A1:2004 +A2:2006
IEC60335-2-2:2002 +A1:2004 +A2:2006
EN 55014-1:2006
EN 55014-2 1997 +A2 2008
EN 50366 2003
A technical construction  le for this equipment is retained at
the manufacturer’s address.
Signed:
Date: 11/05/2010
Name:Allyn Boyes
Position: Technical Manager
Numatic International Limited,
Chard , Somerset.
TA20 2GB
www.numatic.co.uk
GB