Numax SFR2190 - Recommended Hookup; Trouble Solving; Wearing Parts

><מתתשעת
MODEL: SFR2190
1-888-669-5672 HTTP:/WWW.NUMAXTOOLS.COM
MEMO:
NUMA.
MODEL: SFR2190
RECOMMENDED HOOKUP
CAUTION:
The air compressor must be able to
maintain a minimum of 70psi when the
tool is being used. An inadequate air
supply can cause a loss of power and
inconsistent driving.
A WARNING:
Do not connect with an air compressor
which can potentially exceed 200psi. As
tool may burst, possibly causing injury.
Q P
E hie
TROUBLE SOLVING
SUGGESTED
SOLUTIONS
PROBLEMS POSSIBLE CAUSES
1. Loose screws. T. Tighten screws.
2.Womor damaged O-rings or seals. | 2.Install overhaul kit.
Air leaking near the
top of the tool or in
the trigger area.
1. Loose screws. 1. Tighten screws.
2.Wom or damaged O-rings or seals. | 2. Install overhaul kit.
Air leaking near the
bottom of the tool.
1. Make sure the air compressor is
set between 70psi and 115psi.
2. Add about 2-3 drops of lubrication
into the air connector.
3.Clean exhaust channel.
4. Install overhaul kit.
Tool does nothing 1. Inadequate air supply.
or operates sluggishly. | 2. Toolis too dry.
3. Exhaust blocked.
4.Wom or damaged O-rings or seals.
1. Fix the drive channel.
2.Replace the piston.
3.Remove the bent fasteners,
replace with the right fasteners.
4.Clean magazine.
5. Tighten screws.
6 Verify that fasteners
are the correct size.
Fasteners are jammed | 1. Drive channelis worn.
inthe tool frequently. | 2. Piston is broken or wom.
3. Bent fasteners.
4. Dirty magazine.
5.Loose magazine.
6. Wrong fasteners.
Can not fire the tool
A WARNING:
Use only Numax Authorized Repair Parts.For questions please call 1-888-669-5672 or visit
our website at http://www.numaxtools.com
There is no fastener in the magazine. load the fasteners.
WEARING PARTS
Repair parts can be ordered from our website: http://www.numaxtools.com
08 HTTP://WWW.NUMAXTOOLS.COM 1-888-669-5672