1110
USE
USE
Securing Child in the Restraint
4 Place buckle tongues into
the quick release buckle.
IMPORTANT: Both buckle
tongues should "CLICK"
into place. If they do
not click, try again or try
cleaning the buckle. See
page 21.
5 Tighten harness by
pulling on the adjuster
strap at the front of the
restraint.
Note: you may need to
pull excess shoulder
strap webbing through
the Quick Release Buckle
Tongues upward towards
the child’s shoulder and
then pull on the adjuster
strap.
This may need to be
repeated several times
to get the webbing tting
snugly.
"CLICK"
WARNING
DO NOT LEAVE CHILDREN UNATTENDED IN THE CAR
1
2
3
4
5
1 Loosen harness by
pressing on adjuster but-
ton while pulling on the
harness straps.
2 Press button to open
the quick release buckle.
Spread harness straps
apart.
3 Place child in restraint in
seated position.
Child's back must be
rmly against both the
back and bottom of the
restraint.
First check shoulder strap
height and adjust if neces-
sary.
See pages 7 & 8
To Next Page
Loading...
Need help?
General
