18
DIGITAL INPUTS: EXTENSION
Briefly press the Power/Volume knob on the front panel or CH+ & CH- buttons on the remote control to switch through
channels to select EXTENSION.
When EXTENSION is selected, CDP-9 will display the set volume and sample rate with 2 second interval.
Default sample rate is shown on display if SRC is set to OFF. Otherwise, the set SRC sample rate is shown.
If no EXTENSION source is connected to CDP-9 and no SRC is set. Only the volume is displayed. Sample rate will be blank.
DIGITAL INPUTS: AES
Briefly press the Power/Volume knob on the front panel or CH+ & CH- buttons on the remote control to switch through
channels to select AES.
To Next Page
Loading...
