To Next PageTo Next Page
Need help?Do you have a question about the Nussbaum JUMBO LIFT 3200 NT and is the answer not in the manual?
General| Brand | Nussbaum |
|---|---|
| Model | JUMBO LIFT 3200 NT |
| Category | Scissor Lifts |
| Language | English |
Discusses potential hazards, safe operation rules, and organizational measures.
Lists responsibilities for personnel training, safety understanding, and system operation.
Details requirements for maintenance and error removal, emphasizing specialist involvement.
Outlines safety requirements for system setup and testing by trained personnel.
Explains safety symbols and their meanings for hazard identification.
Details requirements for single, regular, and extraordinary safety inspections.
Provides guidelines for system setup, including foundation, anchoring, electrical, and grounding.
Step-by-step guide for filling and venting the hydraulic system.
Procedures for final commissioning and safety inspections before use.
Steps for relocating the lift system and guidance on choosing appropriate anchors.
Identifies and describes the main components of the operating panel.
Instructions for safely driving the vehicle onto the lift and lifting it.
Procedures for safely lowering the vehicle from the lift.
Overview of the maintenance schedule and general precautions.
Annual maintenance checks and tasks for the lift system.
Details the procedure for changing hydraulic oil every two years.
Specifies the replacement of protective and hydraulic hoses every six years.
Guidelines for regular cleaning and care to maintain system value and performance.
Lists possible causes and remedies for the motor failing to start.
Troubleshooting steps for when the motor runs but the load isn't lifted.
Identifies issues and solutions for a lift that fails to lower.
Procedure for safely handling the lift when it encounters an obstacle during lowering.
Step-by-step instructions for emergency lowering in case of power failure.
Provides specifications like weight, load capacity, voltage, and motor details.
Lists and describes the various safety features integrated into the lift system.
Explains the intended use and limitations of the lift system.
Outlines inspection requirements for design changes and location moves.
Provides detailed plans and requirements for sub-floor foundation installation.
Details installation plans and requirements for above-ground foundation setups.
Checklist for the initial safety inspection before the lift is put into operation.
Checklist for routine safety inspections and periodic maintenance.
Checklist for extraordinary safety inspections, e.g., after construction changes.
EU Declaration of Conformity for the JUMBO LIFT 3200 NT model.
EU Declaration of Conformity for the HYMAX XX 3200 PH model.
