What to do if the motor does not start on my Nussbaum Jumbo NT Scissor Lifts?
If the motor of your Nussbaum Scissor Lifts doesn't start, check a few things. First, ensure that the main switch is engaged. Also, check that the feed line is not cut. Confirm there isn't a general power failure. Finally, the thermofuse in the motor might be active; let it cool down for about 10 minutes.
General| Brand | Nussbaum |
|---|---|
| Model | Jumbo NT |
| Category | Scissor Lifts |
| Language | English |
Lists hex key sizes 3 and 6 for cover removal and emergency lowering, plus a 17th wrench for lock nut operations.
Explains filling the hydraulic system with oil to release air and equalize platforms using adjustment screws.
Details the role of adjustment screws (0.10) on the hydraulic block for filling and normal operation.
Lift must be parked low, connected to hydraulic system filled with approx. 14L oil.
Open leveling screws A1/A2 (max 1 turn) and emergency-drain screws N1/N2 for lowering.
Lift platforms without load to top, press lowering button, release when levers are parallel.
Close leveling screws A1/A2 again. Air is released and the lift is equalized.
To Next Page
