Made in Germany
Quick guide
• Lifting the platforms without load to the top-
end position (the platform is unevenly high and
is slightly oblique in the final position, the
cylinder levers are not parallel).
• Press the “lowering” button, the platforms
slightly lowering, release “lowering” button
once the two cylinder levers are exactly
parallel. When the cylinder lever are not
parallel or the platforms are lowered too much,
the equalization does not work.
• Close screws A1 and A2 again.
• Air is released and the lift is equalized.
Cylinder lever not synchronized.
Cylinder lever synchronized.
To Previous Page
Loading...
