Why Nussbaum Play Detector SPID 20.000 has no radio signal?
The Nussbaum Tools might not have a radio signal because the battery is empty. Try recharging or replacing the batteries. Also, the charger or power supply could be defective, so check it. The transmitter and receiver might be too far apart; it only works near the station. If none of these work, the receiver might be defective.
What to do if Nussbaum Play Detector SPID 20.000 Tools has no function?
If your Nussbaum Tools is without function, first check if the main and control switches are turned on. If not, switch them on. Also, ensure the protective switch is engaged. Inspect the cable for any defects. If the thermal protection is active, allow the tool to cool down. Check the battery of the flashlight, and replace if necessary. If the problem persists, the radio transmitter or receiver may be defective.
Why Nussbaum Play Detector SPID 20.000 Tools has no movements?
If your Nussbaum Tools has no movements, the motor might have the wrong rotation direction, so examine it and commutate if necessary. Also, the valves could be defective, so check the valves and coils. Finally, there might not be enough oil, so fill it up and deaerate.
Why do the plates move jerkily on my Nussbaum Play Detector SPID 20.000 Tools?
The plates on your Nussbaum Tools might move jerkily because there is air in the hydraulic system.
To Next Page
General