NuTone BCDF1 User Manual

99045883DCVR08‐18‐2020
AdditionalInformationfor
RangeHoodsmeetingADACompliance
Broan,NuToneandVenmarbrandedresidentialrangehoodscanbeinstalledtocomplywithSections308and
309ofADAGuidelines,whenusedwithappropriatelymountedcontrolsinstalledat15”to48”abovethefloor
andcontrolaccessshouldnotrequirereachingoveracookingappliance.
ThefollowingrangehoodscanworkinanAD
ACompliantsituationwhentherange
hoodiswiredtooperate
from a dedicated, standard electrical wall switch. To facilitate this application, share the informationon the
followingpageswithyourelectricianwhenpreparingfortheinstallation.
THISPROCEDUREAPPLIESTOTHERANGEHOODSERIES
LISTEDATTHEBOTTOM
OFTHISPAGE
Bro
a
n:BCDF1,BKDB1,BCDA1,BKDD1,BKDEG1,BKDF1,CLDA1,CRDEG1,BNDD1,BNDF1,BQDD1,BCDH1,
BCDJ1,BCLB1,BKDJ1,BKDN1,BQLA1,CLDH1,CLLB1,CRDN1.
BroanElite:ALT2,ALT3,ALT4,EPLEC1,EQLD1,ERLE1,TEN2,SPE1.
EuroDesign:
EDJDD1,EDJDN1,EDJLD1.
NuTone:AHDA1,AVDF1,AVDN1,NCDJ1,NCLB1,NKDF1,NKDN1,NPLEC1,NQDD1,NQLA1,NCDA1,NRLE1.
VenmarBistro:VBLDF1,VBLDN1,VBNDH1,VBNLB1.
VenmarChef:VCNDD1,VCQDD1,VCQLA1.

NuTone BCDF1 Specifications

General

Width	30 in
Airflow	300 CFM
Lighting	Incandescent
Control Type	Rocker Switch
Noise Level	6.5 Sones
Sones	6.5
Filter Type	Aluminum Mesh
Model	BCDF1
Brand	NuTone
Power Source	Electric
Mounting Type	Under Cabinet
Material	Steel
Type	Under-cabinet
Dimensions	30 in (W) x 19.75 in (D) x 6 in (H)

Summary

ADA Compliance for Range Hoods

Range Hoods meeting ADA Compliance

Information on range hood installation to comply with ADA guidelines for height and control access.

ADA Low Voltage Wiring Instructions

Safety and Preparation

Safety warnings, tool requirements, and initial setup for wiring.

Wiring Procedure for Single Blower Hoods

Step-by-step guide for wiring single blower range hoods for ADA compliance.

Range Hood Operation

Motor and Light Control Operation

Instructions on operating the motor and lights using the modified wiring setup.

Accessing Range Hood Main Harness

EPLEC1, NPLEC1, SPE1 Series Access

Instructions for accessing the wiring harness for specific EPLEC1, NPLEC1, and SPE1 series hoods.

ALT4, EDJLD1, EQLD1 Series Access

Instructions for accessing the wiring harness for specific ALT4, EDJLD1, and EQLD1 series hoods.

ADA Cable Connections

Connecting the ADA Cable

Detailed steps for connecting the ADA cable to the range hood and control box.

Range Hood Operation with Different Controls

Operation with CapTouch, LCD, and Infrared Controls

How to operate various range hood control types after ADA wiring.