Page 5 of 10
8. Repeat each Fixture [Device] [Unit] [reconnect power].
9. When finished plug in Fixture [Device] [Unit] [reconnect power].
How to replace empty NuTone Haven [Bottle Name] [Repellent Bottle] [Repellent Cartridge] [Repellent Refill] into fixture
[device].
1. Unplug [Disconnect power to] Fixture [Device] [Unit].
If Vaporizer [Liquid] [Repellent] [Emanator] has been
operating, allow at least 1 hour to cool down before
handling.
2. Remove 1 [one] NuTone Haven [Bottle Name]
[Repellent Bottle] [Repellent Cartridge] [Repellent
Refill] from packaging.
3. Place on a flat surface and remove protective cap.
4. Attach locking adaptor cap to bottle with spurs at
bottom, closest to bottom of bottle, and turn until
secure. Once attached properly, this cap is not
removable. Only applicable to certain models
5. Open [Remove] Fixture [Device] [Unit].
6. Remove used [empty] NuTone Haven [Bottle Name]
[Repellent Bottle] [Repellent Cartridge] [Repellent
Refill] from assembly.
To Next Page
Loading...
Need help?
General