NuTone QT110 - Typical Installation Methods; Mounting Housing to Joists; Mounting Housing to I-Joists; Mounting Housing to Trusses

MODEL QT110E
Page 2
PLAN THE INSTALLATION
&RRNLQJ
(TXLSPHQW
)ORRU
&22.,1*$5($
'RQRWLQVWDOODERYHRU
LQVLGHWKLVDUHD

R

R
127)2586(,1
$&22.,1*$5($
TYPICAL
INSTALLATIONS
Housing mounted to I-joists.
Use I-joist spacer block (provided).
Housing mounted to joists.
Housing mounted to truss.
To mount housing anywhere between joists, i-joists or trusses, use
optional hanger bar kit QTHB1 (sold separately). Follow mounting
instructions included with kit.
ROOF CAP*
(with built-in
damper)
WALL CAP*
(with built-in
damper)
4-IN. ROUND
ELBOWS*
4-IN. ROUND
DUCT*
FAN
HOUSING
Seal gaps
around
housing.
Seal duct
joints with
tape.
Keep duct
runs short.
INSULATION
(Place around and
over fan housing.)
POWER
CABLE*
*Purchase
separately.
OR