4
Fit the vessel Blade-side down onto the
Power Base, aligning the actuator tabs. Press
down to begin extraction, gently rotating the Cup
clockwise to lock the cup in place. Extract for no
longer than 1 minute. If more extraction is needed,
wait 1 minute, then repeat the extraction process
in 1 minute intervals up to three times as needed
to achieve the desired consistency. If more than
three 1-minute extractions are needed, allow the
Power Base to cool for 2-3 minutes after the third
extraction before beginning the next round.
NOTE: If the unit is not allowed to cool as instructed, a safety
feature triggers that will power off the unit and temporarily
render it non-functioning. To reset this safety feature, simply
unplug the unit for 15 seconds and plug it back in. Unit will
resume normal function.
NutriBulletBalance.com | 41
N12S_0901_UG Bluetooth update v5.indd 41 1/10/19 6:44 AM
To Next Page
Loading...
