NUTRIBULLET RX NB-301 - How It Works; Extracting for smoothies.

2120
How it works.
Extracting for smoothies.
* DO NOT RUN SOUPERBLAST MODE WITH ANY OF THE
BLENDING CUPS ONLY USE THE VENTED SOUPERBLAST
PITCHER READ ALL SAFETY INSTRUCTIONS FIRST!
Plug the motor base into an
electrical outlet. Press the
power button, located 90˚
to the left side of the
n.-
Button, to turn the machine
on. The power button light
will glow BLUE, signifying
power. Next, place the cup
blade-side-down onto the
3
4
motor base. This will activate
the nutribullet Rx
®
’s SMART
Technology function, causing
the n.-Button at the front
of the unit to glow GREEN,
and initiating the 1-minute
extraction cycle.
When the cycle has
completed and the GREEN
light has turned o , turn o
the unit by depressing the
power button, located 90˚ to
the left side of the n.-Button.
The BLUE light will stop
glowing, signifying the
power is o .
1 Add ingredients into one of
the cups.
2 Fill with liquid up to the MAX
Line. Then, twist the extractor
blade onto the cup and
tighten by hand to make sure
the vessel is sealed.
• NOTE: If at any time the n.-
Button is pushed for 2 seconds,
the button will turn ORANGE
and initiate souperblast mode.
TO TURN OFF THE MACHINE
AT ANYTIME DURING THE
SMOOTHIE CYCLE (n.
BUTTON WILL BE GREEN),
press the power button,
located 90˚ to the left side of
the n.-Button or lift the cup
o the motor base.
NOTE: You can remove the cup
at any time during the blending
cycle by simply lifting the cup
o of the motor base. If more
extraction is required, lift the
cup o of the motor base, wait
15 seconds, then return it back
onto the motor base to start
another SMART Technology
cycle. Do not repeat more than
3 consecutive cycles resting
15 seconds between cycles. If
you press the GREEN
n.-Button
for 2 seconds and the light turns
ORANGE, you have switched
in souperblast mode. Simply
lift the cup o the motor base
at any time to exit this mode
or press the power button,
located 90˚ to the left side of
the n.-Button. When the vessel
is removed from the motor
base, only the n.-Button light
will turn o . When the power
o button is pressed, the BLUE
light will turn o and the blade
will stop spinning. Always press
the power o button upon
completion of processing.
WARNING!
Original Rx Color