NUTRIBULLET ultra - Cleaning Extractor Blades; Cleaning the Motor Base; Cleaning Cups and Lids

25
EXTRACTOR BLADES:
• Rinse the Rapid Extractor
Blade with warm, soapy
water.
• Use a small brush or sponge
dampened in soapy water to
remove any residue on the
Rapid Extractor Blade.
NOTE: It’s best to clean the Rapid
Extractor Blade immediately after
use to avoid the buildup of residue.
MOTOR BASE:
• Use a sponge or dishcloth
dampened with soapy water
to clean the surface of the
Motor Base.
• Use a small brush to scrub
the actuator system of the
Motor Base.
CUPS & TO-GO LIDS:
• Cups and To-Go Lids are
dishwasher-safe. Rinse or
scrub beforehand to remove
any debris.
WARNING! NEVER place
the Rapid Extractor Blade,
Cups or To-Go Lids on
the bottom rack or use
the heat/sanitize cycle
of your dishwasher when
cleaning, as this may cause
warping and possible safety
hazards.
1 Once blending is complete,
make sure your nutribullet
®
Ultra Motor Base is powered
o and unplugged from its
outlet.
2 Detach the nutribullet
®
Cup
and Rapid Extractor Blade
from the Motor Base.
3 Clean the individual
components as follows:
Cleaning: #1
Cleaning #2