Safety Feature Alert: The blender is equipped with a thermal overheat protector that will shut off
the motor if the blender overheats. To reset, unplug and allow the blender to cool for approximately
1 minute before using again.
Safety is key to enjoying your Smoothie Blender to the fullest. Take a moment to review these simple
tips regularly—they're the secret ingredient to blending up fun with peace of mind!
2
3
SAFETY FIRST - PAY ATTENTION!
SAFETY FIRST - PAY ATTENTION!
Do not expose the jar to extreme temperature changes.
The jar, lid and blade assembly are not intended to be used in the microwave as it may cause
damage.
Do not blend hot liquids, as doing so may cause excessive pressure build-up and possible burns.
Do not operate this appliance on or near any hot surfaces (such as gas or electric burner or in a
heated oven).
If the jar feels warm on touch during the blending process, allow it to cool. Point it away from your
body and open it carefully. This is because friction from rotating blades during blending can cause
ingredients to heat up and generate internal pressure in a sealed container.
Damage Due to Heat
This product is intended for household use only. Do not use the blender for commercial purposes or
anything other than its intended use.
The KRÜSH comes with a blade which is designed specifically for smoothies/ liquids/ wet blending.
Please do not use this blade and jar for dry grinding. If you want to process dry ingredients, add
liquid to the ingredients of the Go Jar™.
Do not leave the blade assembly attached to the jar with food ingredients inside either before or
after blending. Some foods can release gases if left in a sealed container, leading to excessive
pressure build-up and potential injuries. For ingredient storage, use only the lid to cover.
Ensure hands, hair, and clothing are away from the blender while operating.
Do not use any accessories other than those recommended by Nuuk.
Usage
Electrical Safety
Ensure that your power supply matches the voltage specified on the blender.
Nuuk Pro Tip: Always check for voltage compatibility between your product and mains supply.
Do not let the cord come in touch with the hot surface.
Ensure that the cord is not twisted or pulled especially while unplugging. Instead hold the power plug
and pull it out from the power socket.
Do not let the power cord hang over the edge of the table or counter or touch hot surfaces such as
the stove.
Avoid Damage to Cord
Nuuk Pro Tip: Always use Nuuk Cable Organizer to secure the power cord properly during storage and
prevent any damage.
Safety Feature Alert: Never operate the blender (or any appliance) if it has a damaged cord or plug,
if it is not working properly, or if it has been dropped or damaged.
Do not use the appliance with wet hands.
Do not place or store the blender where it can fall or be pulled into a tub, sink, water or other liquids.
If the blender falls into water, do not reach into the water directly, instead unplug it first. Do not
operate it. Reach out to us at Nuuk Customer Care to speak to a Product Specialist.
Do not attempt to repair the blender. Incorrect reassembly or repair could cause a risk of fire,
electric shock, or injury to persons when the blender is used. It is only repairable or replaceable by
Nuuk’s trained Product Technicians.
Always unplug the blender immediately after use and before cleaning. To unplug, grasp the plug and
pull from the electrical outlet. Never pull from the power cord.
To reduce likelihood of circuit overload, do not operate another high-wattage appliance on the same
circuit.
Nuuk_KRÜSH User Guide
Nuuk_KRÜSH User Guide
To Next Page
Loading...