Control Panel
Drive Foot Switch
Engages / disengages the overdrive.
Preamp Foot Switch
Engages / disengages the preamp.
Noise Gate: Push and hold the Drive
footswitch for 1.5 seconds, the green LED
light will start to blink. Now you can control
the noise gate Decay by Blend knob, and
Gate Threshold by Drive knob. When you
turn the Threshold to 0, noise gate will be
OFF.
Decay:Adjusts the speed of the noise gate.
Threshold: Adjusts the gate level.
Hold the Drive footswitch for 1.5 seconds
again to go back to use the pedal. Green
LED will stop blinking.
I/O Jacks
1/4" Mono Jack Input
Power Input
Ground Lift Toggle
1/4” Main Output
1/4” Through Output
Input to DI Signal Routing Toggle
Micro B USB
1/8” Auxiliary Input XLR DI Output
1/8” Headphone Output
Activates the Impulse Response speaker
cabinet simulation for DI out and the
headphone out.
Activates the Impulse Response speaker
cabinet simulation for main output.
DI toggle
OUT toggle
To Next Page
Loading...
Need help?
General
