- 14 -
January 2010
6) After a further 1-2 seconds, release the recovery button
7) Connect a mini-USB to USB-A cable between the host PC and the mini-USB jack on the rear-left
corner of the Harmony main board.
8) If this is the first time that the host PC has been used to flash a Harmony device, then you may
be prompted to install the USB driver for the newly-found device. This driver should have been
supplied with the operating system image, as it is dependent upon the host PC OS used to flash
the device. See the following section for a discussion of this process on Windows XP.
9) Once the driver is confirmed to be running, the device is in recovery mode. Continue following
the platform pack’s OS install instructions to complete the OS installation.
To Next Page
Loading...