Need help?Do you have a question about the NVX BE-TSLAS-VCW104 and is the answer not in the manual?
Use a soft plastic panel removal tool to detach the upper trim panel for enclosure installation.
Place the BE-TSLAS-VCW104 enclosure into the designated spot, bottom first, ensuring the tab is behind the lip.
Outline the bracket shape on the vehicle's metal panel and mark the center hole for drilling. Drill a 7/16" hole.
Insert the supplied Jack Nut into the drilled hole and cover it with dampening material, cutting the center.
Connect speaker wires to the terminal posts, ensuring correct polarity for positive and negative connections.
Thread a 1/4-20 10mm bolt with a washer into the Jack Nut until the Jack Nut collapses, avoiding overtightening.
Once the enclosure is mounted, reinstall the trim panel in reverse. Enjoy your new BE-TSLAS-VCW104.
Recommends professional installation for best performance and safety. Contact NVX for questions.
To Next Page
General