9
P3
CON MAX 20~63 Contrast maximum value Setting 50
CON CEN 10~50 Contrast center value Setting 35
CON MIN 0~40 Contrast minimum value Setting 0
BRI MAX 20~63 Brightness maximum value Setting 50
BRI CEN 10~50 Brightness center value Setting 25
BRI MIN 0~40 Brightness minimum value Setting 0
SHARP MAX 32~63 Sharpness maximum value Setting 63
SHARP MIN 0~31 Sharpness minimum value Setting 0
SUB COL 0~63 Sub colour value Setting 28
SUB TINT 0~32 Sub tint value Setting 16
P4
PWL 0~1
Peak white limiting 0:peak white limiting circuit
not active 1:peak white limiting circuit active
1
PWL ADJ 0~15 Peak white adjust 4
SOFTCLIPLV 0~3 Soft clip adjust 1
BLK SW 0~1 Baack stretch 1
BLK DEP 0~1 Black stretch Depth 0:15IRE 1:30 IRE 1
AUTO BLK 0~3 Black area to switch off the black stretch 1
GAMMA 0~1 GAMMA Control 0
AFTER(-)SH 0~2 Ratio pre-and aftershoot 1
OVER(-)SH 0~3 Ratio of positive and negative peaks 1
BPD 0~1 0~1 0
P5
VLF-VHF FS 0~255
FS Tuner frequency setting of VLF-VHF
0~255(100.0~227.5 MHz)
87
VHF-UHF FS 0~255
FS Tuner frequency setting of VHF-UHF
0~255{300.5~555.5MHz}
127
U-BAND-ALTFS 0~1 FS Tuner register setting of UHF BAND 0
BAND-SEL VS 0~2 VS Tuner BAND Control setting 2
VOL10 0~100 V.P10 volume of VALUE 10
VOL25 0~100 V.P25 volume of VALUE 25
VOL50 0~100 V.P50 volume of VALUE 50
VOL100 0~100 V.P75 volume of VALUE 100
LSR VOL 0~63 MAX volume 63
ENG.PAGE 0~1 Engineer menu switch 0
P6
AKB 0~1 Black current stabilization 1
CMB P7 0~2 Pin 7 function setting 0: AVL, 1:SIF output, 2:FM
output
2
SSL 0~1
Slicing level for horizontal sync separator 0:50%
1:30%,direction top sync
0
FSL 0~1 Forced slicing level for vertical sync 0
To Next Page
Loading...