NXP Semiconductors UM11490 - Page 27

NXP Semiconductors
UM11490
Feature Configuration Guide for NXP-based Wireless Modules on i.MX 8M Quad EVK
Step 3 - Start iPerf on the server
Use the following command to start iPerf on the Ubuntu station connected with the
external Wi-Fi Router as a server.
root@ubuntu-desktop:/# iperf -s -i 1
Command output example:
-----------------------------------------------------------
Server listening on 5201
-----------------------------------------------------------
Accepted connection from 192.168.1.3, port 47590
[ 5] local 192.168.1.2 port 5201 connected to 192.168.1.3 port 55286
[ ID] Interval Transfer Bandwidth Jitter Lost/Total
Datagrams
[ 5] 0.00-1.00 sec XX.XX MBytes XXX.X Mbits/sec X.XXX ms XX/XXXX (XX
%)
[ 5] 1.00-2.00 sec XX.XX MBytes XXX.X Mbits/sec X.XXX ms XX/XXXX (XX
%)
[ 5] 2.00-3.00 sec XX.XX MBytes XXX.X Mbits/sec X.XXX ms XX/XXXX (XX
%)
[ 5] 3.00-4.00 sec XX.XX MBytes XXX.X Mbits/sec X.XXX ms XX/XXXX (XX
%)
[ 5] 4.00-5.00 sec XX.XX MBytes XXX.X Mbits/sec X.XXX ms XX/XXXX (XX
%)
[ 5] 5.00-6.00 sec XX.XX MBytes XXX.X Mbits/sec X.XXX ms XX/XXXX (XX
%)
[ 5] 6.00-7.00 sec XX.XX MBytes XXX.X Mbits/sec X.XXX ms XX/XXXX (XX
%)
[ 5] 7.00-8.00 sec XX.XX MBytes XXX.X Mbits/sec X.XXX ms XX/XXXX (XX
%)
[ 5] 8.00-9.00 sec XX.XX MBytes XXX.X Mbits/sec X.XXX ms XX/XXXX (XX
%)
[ 5] 9.00-10.00 sec XX.XX MBytes XXX.X Mbits/sec X.XXX ms XX/XXXX (XX
%)
[ 5] 10.00-10.52 sec XX.XX MBytes XXX.X Mbits/sec X.XXX ms XX/XXXX (XX
%)
- - - - - - - - - - - - - - - - - - - - - - - - -
[ ID] Interval Transfer Bandwidth Jitter Lost/Total
Datagrams
[ 5] 0.00-10.52 sec XXX.X MBytes XXX.X Mbits/sec X.XXX ms XXXX/XXXXX
(XX%)
-----------------------------------------------------------
UM11490 All information provided in this document is subject to legal disclaimers. © NXP B.V. 2021. All rights reserved.
User manual Rev. 2 — 29 January 2021
27 / 88