NXP Semiconductors
UM11490
Feature Configuration Guide for NXP-based Wireless Modules on i.MX 8M Quad EVK
Where:
Parameter Definition
start/stop
Start/stop enable
• 0 = disable
• 1 = enable
continuous wave mode
Continuous wave mode enable
• 0 = disable
• 1 = enable
payload pattern Payload pattern value in the range of 0 to 0xFFFFFFFF.
cs mode
CS mode - Applicable only when continuous wave is disabled
• 0 = disable
• 1 = enable
active subchannel
Active sub-channel
• 0 = low
• 1 = upper
• 3 = both
tx data rate
Transmit data rate index corresponding to legacy/HT/VHT
rates
UM11490 All information provided in this document is subject to legal disclaimers. © NXP B.V. 2021. All rights reserved.
User manual Rev. 2 — 29 January 2021
34 / 88
To Next Page
Loading...