NXP Semiconductors UM11490 - Page 75

NXP Semiconductors
UM11490
Feature Configuration Guide for NXP-based Wireless Modules on i.MX 8M Quad EVK
Parameter Length Definition
TestScenario 1
Test scenario
• 0x01 = receiver test, 0–pattern
• 0x02 = receiver test, 1–pattern
• 0x03 = receiver test, 1010–pattern
• 0x04 = receiver test, PRBS–pattern
• 0x09 = receiver test, 1111 0000–pattern
• 0xFF = abort test mode
TxFrequency 1
Transmit frequency
f = (2402+k) MHz
RxFrequency 1
Receive frequency
f = (2402+k) MHz
TestPacketType 1 Test Packet Type
• 0x03 = DM1
• 0x04 = DH1
• 0x0A = DM3
• 0x0B = DH3
• 0x0E = DM5
• 0x0F = DH5
• 0x14 = 2-DH1
• 0x18 = 3-DH1
• 0x1A = 2-DH3
• 0x1B = 3-DH3
• 0x1E = 2-DH5
• 0x1F = 3-DH5
Expected Number
of Packets
4 --
Length of Test
Data
2 Should not be bigger than the maximum size of the specified
test packet type
Tx AM Address 1 Default = 0x01
Transmitter BD
Address
6 This is used to derive the access code
Report error
packets
1 Report Error Packets
• 0x00 = none (default)
• 0x01 to 0xFE = number of packets to report
UM11490 All information provided in this document is subject to legal disclaimers. © NXP B.V. 2021. All rights reserved.
User manual Rev. 2 — 29 January 2021
75 / 88