NXR LST3622 - User Manual

Questions and Answers

S
Sean MooreAug 13, 2025
Why are the burner flames very large and yellow on my NXR hob?
- A
  Amanda BarryAug 14, 2025
  If your NXR hob's burner flames are very large and yellow, it could be due to clogged burner bezel ports, improperly positioned burner ports or caps, using the wrong type of gas, or a faulty regulator. Try cleaning the burner bezel ring ports with a straightened paper clip, needle, or wire. Also, remove and carefully reinstall the burner bezel and caps. Ensure that the type of rangetop matches the natural gas supply. Check the installation, replace the regulator, or set the regulator for the proper gas.
R
rguerreroAug 17, 2025
What to do if top burners do not light or do not burn evenly on my NXR hob?
- A
  Adam RamosAug 17, 2025
  If the top burners of your NXR hob do not light or burn evenly, ensure the unit is properly connected to the power supply. The issue could stem from the plug not being completely inserted or clogged burner holes. Remove the burner heads and clean them. Also, check the electrode area for any burned-on food or grease.
T
Tracy RichardsonAug 20, 2025
What to do if my NXR hob is sparking but no flame ignition?
- S
  Steve PetersonAug 20, 2025
  If your NXR hob is sparking but there is no flame ignition, check if the gas shut-off valve is in the ‘OFF’ position. If it is, turn the shut-off valve to the ‘ON’ position.
A
Anna McintyreAug 25, 2025
Why do the igniters spark continuously after flame ignition on my NXR hob?
- J
  justin43Aug 25, 2025
  If the igniters on your NXR hob spark continuously after flame ignition, it could be due to reversed power supply polarity or wet/dirty igniters. Have the polarity corrected, and dry or clean the igniters.
R
reedtheresaAug 28, 2025
What to do if nothing works on my NXR hob?
- D
  danielsmichaelAug 28, 2025
  If nothing works on your NXR hob, the rangetop might not be connected to the electrical power or the power supply is not energized. Have a qualified electrician connect the rangetop to a properly sized electrical power supply and check the power supply, including the house circuit breaker, wiring, and fuses.
E
Eric MunozSep 1, 2025
Why does the burner flame go out at low setting on my NXR hob?
- G
  Gail RodriguezSep 1, 2025
  If the burner flame goes out at a low setting on your NXR hob, it could be due to low gas supply pressure or obstructed air intake holes around the knobs. Contact your gas company to check the gas supply pressure and remove any obstructions around the air intake holes.
S
Sarah NorrisSep 4, 2025
Why are foods over-cooked or under-cooked on my NXR hob?
- K
  Kathryn PhelpsSep 4, 2025
  If foods are over-cooked or under-cooked on your NXR hob, it could be due to incorrect cooking time or temperature. Adjust the time, temperature, or rack position accordingly.
F
fnewtonSep 8, 2025
Why is my NXR hob making a ‘cracking’ or ‘Popping’ sound?
- A
  Amy HughesSep 8, 2025
  The 'cracking' or 'popping' sound you hear from your NXR hob is the sound of metal heating and cooling. This is normal.