Need help?Do you have a question about the NXS NX500.1 and is the answer not in the manual?
Proper installation maximizes performance. Recommend authorized retailer or careful DIY.
Control amplifier DSP via PC using USB interface and software.
Optional in-dash controller for PC-free setup and control. Features LCD, scroll wheel, presets.
Remote control for amplifier output level, allows selection of amplifier/channels.
Fuse power wire at battery, use quality connectors, avoid routing under vehicle.
Mount with caution, route wires away from electrical, avoid sharp edges, ensure proper grounding.
Built-in DSP for comprehensive audio adjustments via optional controllers.
Includes DC Offset, Short Circuit, and Thermal Protection for amplifier longevity.
Power Bridge technology combines amps; High Level Input connects to factory radios.
Line Out for expansion, Power Fusing for protection, Remote Turn-on for power management.
Fine-tune level matching between source and amplifier for optimal performance.
Select a ventilated location, use caution with vehicle components, and secure the amplifier properly.
Connect amplifier to car battery using proper gauge wire and in-line fuse.
Connect amplifier's ground terminal to the vehicle's chassis with a short wire.
Connect to the radio's remote output for synchronized power control.
Connect amplifier to car battery using appropriate gauge wire and fuse.
Connect amplifier's ground terminal to the vehicle's chassis with a short wire.
Connect to the radio's remote output for synchronized power control.
Connect amplifier to car battery using appropriate gauge wire and fuse.
Connect amplifier's ground terminal to the vehicle's chassis with a short wire.
Connect to the radio's remote output for synchronized power control.
Connect head unit RCA outputs to amplifier RCA inputs, route wires away from noise.
Details two-channel and four-channel input setups for the NX400.4 amplifier.
Connect two channels from a factory radio to the NX900.5 for five-channel output.
Connect four or five channels from a factory radio to the NX900.5.
Connect to factory radios with floating ground using high-level inputs.
Connect NX400.4 to factory radios with floating ground via high-level inputs.
Connect two channels from a factory radio to the NX900.5 using high-level inputs.
Connect four or five channels from a factory radio to the NX900.5.
Connect speakers to NX500.1, ensuring a minimum 2 Ohm load for each channel.
Connect speakers to NX1000.1/NX2000.1, ensuring a minimum 1 Ohm load.
Connect speakers to NX200.2 and NX400.2, minimum 2 Ohm load per channel.
Connect speakers to NX400.4, ensuring a minimum 2 Ohm load per channel.
Connect speakers to NX900.5, adhering to minimum load requirements.
Set amplifier addresses using dip switches for control via NXLCDC or NXLI.
Connect and configure two identical amplifiers in Power Bridge mode for increased power.
Remotely adjust amplifier output level for specific channels using NXLCDC or NXLC.
Adjust input gain to match radio output, maximizing sound without distortion.
Guide for diagnosing and resolving common problems like no output, low output, noise, and protection mode.
Detailed technical data including output power, frequency response, and dimensions for all models.
To Next Page
General