Operating Instructions
Spraying:
Cleaning:
Pressurise the bottle by pumping the lever up
to 30 times. Do not over pressurise.
Air will escape through the safety valve if the
pressure is too high.
Spray the desired area by holding down the
trigger on the nozzle. The trigger can be
locked for continual spraying.
Choose the type of nozzle according to your
spraying application.
Ensure that pressure is released and that all
sprayer components are rinsed thoroughly
with water after use. This can be achieved by
filling the bottle with clean water, pressurising
and then emptying via the nozzle.
To Next Page
Loading...