1
2
Nyne Performer
2
3.sec
1
1
2
3.sec
Charge the speaker until all four charging indicators
light up, indicating that the battery is fully charged.
Tips:
1
To save power, when the speaker is not in use,
always turn the power switch to the O position.
2
You can press PUSH to turn on the charging
indicators and hold the button to turn off. When
only the red indicator is on, it indicates that the
battery is low and needs to be recharged.
Make sure the power switch is in I position,
then hold to switch on.
To switch to standby mode, hold again.
To power off completely, turn the power
switch to the O position.
Performer
Quick User Guide
PA Speaker
nyne.com
EN
EN
1
Press
to select the Bluetooth sound source.
2
Enable Bluetooth on your device to be paired with the speaker.
3
Select ‘Nyne Performer’ from the available devices (if necessary,
enter the password such as ‘0000’ or ‘1234’) to start pairing and
connection with the speaker.
+
After successful pairing and connection, the speaker beeps.
4
Play music on your device paired and connected with the
speaker.
During music play:
•
Turn the volume knob to adjust volume.
•
Press to pause or resume music play.
•
Press to skip to the previous/next song.
•
Hold to fast forward or reverse.
Tips:
This speaker supports automatic connection with a
previously paired device after power-off and power-on again.
To pair with a new Bluetooth device or connect a previously
paired device, rst hold to disconnect the current Bluetooth
device, and then repeat the above steps 2 to 3.
1
To get better reception, fully pull out the draw bar to
work as the FM antenna.
2
Press
to select the FM radio sound source.
3
a. Press repeatedly to tune to a station step
by step.
b. Hold to tune to a station automatically.
To program FM radio stations:
1
a. Hold to start search and program available
stations automatically.
b. Tune to a station with , then hold a
numeric key (1 to 5) to assign a program number to
it. Repeat the steps to add more stations into your
program list.
2
Press a numeric key (1 to 5) to select the
corresponding station in your program list.
1
Press to select the USB sound source.
2
Connect a USB stick containing playable
audio les to the socket.
+
The speaker reads audio les and
then plays them automatically.
During music play:
•
Turn the volume knob to adjust volume.
•
Press to pause or resume music play.
•
Press to skip to the previous/next song.
•
You can also use the numeric key (1
to 5) to select a le directly. To enter a
number with more than one digit, press the
corresponding numeric keys consecutively.
•
Hold to fast forward or reverse.
•
Press repeatedly to select a
repeat/shufe play mode.
To Next Page
Need help?
General
