⑥
End of starting mode[revolutions]
⑨
Head temperature compensation
⑩
⑦
Fuel increase rate at startup
⑧
OPERATION (EC11-LINK)
・Setting of extra fuel injection at engine start. The parameter shows how much percentage (%) of fuel is
to be added to the basic fuel injection. Usually the parameter is 100%. Double quantity of fuel is injected
when the parameter is 100%.
・Increase/decrease fuel injection according to altitude. The parameter can be input at 13 points by 500m
interval from -1000～5000m. The parameter shows how much extra fuel is added to the basic fuel
injection by percentage (%). The altitude between the points is complemented by the lower and higher
points. The parameter at -1000m is applied to below -1000m, and the one at 5000m is applied to more
than 5000m.
Setting of the timing to release “engine starting mode”. The counting starts when engine rpm excess
960rpm. You input the parameter to decide how many revolutions after the first 960rpm “engine starting
mode” is released. The parameter is usually 50 revolutions.
・Increasing fuel injection according to the rise of Cylinder Head temperature (CHT).
This is the function to stabilize engine operation at low temperature and prevent the engine from
overheating at high temperature. The parameter can be input at 16 points, by 20℃ interval between 0～
300℃. The parameter shows how much extra fuel is added to the basic fuel injection by percentage (%).
The temperature between the points is complemented by the lower and higher points. The parameter at
0℃ is applied to below 0℃, and the one at 300℃ is applied to more than 300℃. Use the default
settings in an ordinary case.
Setting of the central parameter (neutral) of Fuel increase/decrease adjustment signal (PWM). Set the
parameter according to a receiver or flight controller you use. The pulse width parameter input here is
the neutral position. Fuel increases/decreases ±30％in the range of ±420μs. Positive (+) side increases
fuel injection and negative (-) side decreases. The default setting is 1520μs, which is the neutral position
of Futaba receiver.
@300
℃
@ 20
℃
@ 40
℃
@ 60
℃
@ 80
℃
@ 100
℃
@ 120
℃
@ 140
℃
@ 160
@ 180
℃
@ 200
℃
@ 220
℃
@ 260
℃
@ 280
@ 0
℃
@ 240
℃
@-500
ｍ
@ 0
ｍ
@ 500
ｍ
@1000m
@ 1500m @ 2000m @ 2500m @ 3000m @ 3500m
@ 4500m @ 5000m
@-1000
ｍ
@ 4000m
To Next Page
Loading...