：
・Do not miss to click [Save Settings] button (B12) to write the input data in the ECU memory into
the flash memory. Turning off the ECU without doing so causes loss of all the input parameters.
・Setting items ①～④ are the “Teaching processes” of throttle position.
・Do not change the parameters except for ①～⑤ unless it is needed. The engine performance
might get worse.
・Settings of input side of throttle signal is adjusted using the following “MONITOR” function.
Opening of throttle valve is affected by the setting of throttle servo position. Set throttle signal
input after “Teaching processes” (①～④).
OPERATION (EC11-LINK)
To Next Page
Loading...