As the recoil starter is of unit construction, re-
placement parts are not available. Replace-
ment recoil starters are obtainable only as
complete units.
Do not pull the starter cord more than 50cm (20
in.). Do not abruptly release the starter knob.
Allow the cord to rewind slowly by holding on
to the knob.
Pull the knob straight so that the cord does not
touch the helicopter body, etc.
Warning!
Note:
1.
3.
Do not attempt to disassemble the recoil starter:
the very strong spring inside will spring out,
which is very dangerous.
2.
Front view
CORRECT
Side view
Top surfaces are in the same plane.
Re-align the surfaces as necessary
INCORRECT
Top surfaces are not
in the same plane.
Top surfaces are not in the
same plane.
Engine does not rest firmly.
BEFORE STARTING
Tools, accessories, etc.
The following items are necessary for operating the
engine.
1 Fuel
Model glowplug engine fuel of good quality, preferably
containing a small percentage of nitromethane.
2 Glowplug
O.S. A3 glowplug is installed in the engine.
NOTES CONCERNING THE RECOIL STARTER
( 32SX-HX ONLY)
8
To Next Page
Loading...
Need help?
General
