Oakley JUDGE II User Manual

TO ADJUST THE CHRONOGRAPH HANDS:
1. If the chronograph hands currently show a mea-
sured time, use button “B” to reset them near the
zero position.
Note that the hands must be stopped with button
“A” to allow button “B” to reset them.
2. Pull the crown out to the second click position (b).
3. Press button “A” and button “B” at the same time
and keep them pressed for at least two seconds.
This puts the chronograph in correction mode.
4. Press button “A” to adjust the chronograph hand
that measures seconds. Each press moves the
hand one short step; press and hold the button for
continuous movement.
5. Press button “B” then use button “A” to adjust
the chronograph hands that measure minutes and
hours. Each press of button “A” moves the minute
hand one short step; press and hold the button for
continuous movement.
6. Push the crown back down against the case.
POS A POS B
Button B
Button A
Hour hand
p1
Chrono
minute hand
Chrono hour
hand
Minute hand
Chrono second hand
Crown
Button B
Button A
p4
AB
Button B
Button A
p5
Button B
Button A
p2-3
Chrono
minute hand
Chrono
hour hand
Chrono second hand
JUDGE
®
II INSTRUCTION MANUAL 05
ADJUSTING THE CHRONOGRAPH HANDS
When the chronograph is reset with button “B,” the three chronograph hands return to the zero position. If
the chronograph hands do not align precisely with the zero position (such as after a battery change), use the
following procedure to adjust them.

Oakley JUDGE II Specifications

General

Brand	Oakley
Model	JUDGE II
Category	Watch
Language	English