EN
7
Safety information
Electrical connection
• Only connect the unit if the electrical data of the unit and the power supply match.
• Only plug the unit into a correctly installed outlet.
• The device is to be supplied through a residual current device (RCD) having a rated residual op-
erating current not exceeding 30 mA.
• Protect open plugs and sockets from moisture.
Safe operation
• Do not use the unit, if electrical lines or the housing are damaged.
• The supply cord cannot be replaced. If the cord is damaged, the appliance should be scrapped.
• The impeller unit in the pump contains a magnet with a strong magnetic field that may affect
the operation of pacemakers or implantable cardioverter defibrillators (ICDs). Keep a distance
of at least 0.2 m between the implant and the magnet.
• Do not carry or pull the unit by its power cable.
• Route lines in such a way that they are protected from damage and do not present a tripping
hazard.
• Should problems occur, please contact the authorised customer service or OASE.
Intended use
Only use the product described in this manual as follows:
• Pumping of normal water for creating fountains.
• While adhering to the technical specifications.
The following restrictions apply to the unit:
• Do not use in swimming ponds.
• Never use the unit with fluids other than water.
• Never run the unit without water.
• Do not use for commercial or industrial purposes.
To Next Page
Loading...
Need help?
General
